I'm having trouble updating the firmware for my axe fx from 10.03 to 11.00, using my profire 2626 at the midi connection between the axe fx and computer. When I go to update the firmware, using SysEx Librarian, the update will start, but it runs very slowly and will never complete. A couple times after the update automatically failed and terminated itself, an error message would pop up and state (not word for word), "Check hardware connections and I/O's" To my knowledge, everything is connected properly, so maybe my interface, the profire 2626, just is not compatible with the axe fx.
On another forum, someone suggested that if I cannot get the profire 2626 to work as the midi connection between the computer and axe fx, I should try the m-audio midisport 2x2, which is also recommended on the wiki axe fx page.
Does anybody else use the midisport 2x2? If so, have you had any issues with updating the axe fx firmware when using the 2x2? I would hate to go out and buy an interface, just to have potentially more issues with it. Especially since I am not tech savvy at all.
Im not sure about the ultra or standard,but for the axe fx 2 you have to set up your axe fx to receive a firmware file.Try looking through the manual again.Read line for line.I missed that part out a few times too.