I'm switching out both pickups on my Cort M520. I found a diagram on Seymour Duncan's site that's close but not quite right - 2 humbuckers, 3-way switch, 1 tone, one volume - but my guitar has a push/pull coil split on tone instead of volume...
The SD diagram: https://www.dropbox.com/s/tahxqhwef1..._1t_3w_1pp.pdf
My guitar after removing the pickups: https://www.dropbox.com/s/9ms1jyeloj0b90h/CortM520.pdf
What goes where? Bridge and neck are two SD humbuckers with four wires...
Wirelessly posted (Hivemind)
You'll wore it exactly the same, just move the location of the box. The same wires go to it.
There is 0 practical electrical interplay between a switch and pot on a push pull pot. They are mechanically attached, but not electrically.