Well I had scrap wood left from making my studio table so......
11" x 30" oak barn board plus two pieces of MDF with maple finish cut to be 3" tall on the one end and rising up to 7" on the other end.
This should leave ample room for mounting the voodoo pedal power 2 underneath.
What is the safest way to drill holes on the angled board? I have a dewalt hammer drill plus a cordless Ridgid 18V. Willing to buy bits or what have you to do this.
How many holes and where should I drill to run the power cables to the Voodoo labs?
Should I add anything else?
Should I run some of strip of that Velcro tape across the board?
Planning on sanding, staining and clear coating this bad boy.
A hammer drill? Nah, the cordless should be fine.
Where to put them? No idea. That's why I bought a Pedaltrain