Is there a video (hell even a set of instuctions with pics would do) that explains how to setup a tremolo on a PRS? Im mainly looking at how to properly set the 6 set? screws. Im having issues not being able to lower my action on my PRS SE CU24. The saddle is bottomed out and the trem is sitting about 2mm off the body (not 1.5mm like recommended).
FYI, im ok at setups. The nut looks good, there is a little relief but not to much (jsut how i like it) and the tremolo is floating evenly.
I found this vid that explains how to setup a replacement PRS trem but im not sure if those instructions are valid for the stock trem.
I'm not familiar with the PRS bridge design, but shouldn't you be ale to screw the trem studs a little further into the body to lower the bridge, like on a Strat bridge?
Actually, watching that video, it's a six point, huh? It sort of looks like you can do the same thing by tightening the 6 screws a couple quarter turns...?