Search Results for ‘impedance’

So, as you may know, I picked up a full-size 6505+ amp head a short time ago. I have it hooked to an Avatar Contemporary 212 cabinet. (See photo for jack plate) Hooking it to 4 ohm impedance works just fine. I haven't tried 8 ohm stereo yet, but when I connect it to 16 ohm mono, I get no...

I asked this about the Fractal in another thread, but figured it was worth a new thread since it's a different animal. If I'm sending a DI out of Reaper via my interface (MOTU 828) into my Mark V, I need a reamp box, correct? Crooks mentioned this guy in the other thread: Amazon.com: Radial...

How's that for a catch all title? I found this post over on the FAS forum: Reamping I got hiss - Page 2 And am still not 100% clear. When I reamp, all I do is use one of the rear TRS outs on my MOTU 828 and send that into the rear of my Axe-Fx II. My DI signal is obviously a lot lower output...

Was thinking about something as I was moving my setup around a bit. I've got a stereo cabinet which I can run either in 4 ohm or 16 ohm operation when in mono. Does it really make a difference which one I pick? Does the amp respond differently?