Metal Guitarist Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-10 of 10 Results
  1. Guitar: Tech, Electronics and DIY
    My 5150 works fine, but a few of the pots are scratchy/dodgy. I figure while I'm in there the amp is old enough that I may as well do all of them. I can crack it open and look but it's not exactly the quickest process. So before I break it open and eyeball them, would anyone happen to have a...
  2. Guitar: Gear Discussion
    I'm going to have some free(ish) time coming up, and I'd like to to have a go at building a SLO. What's the best schematic to use out there?
  3. Guitar: Tech, Electronics and DIY
    Was referencing this to rewire my guitar since the factory wiring looked shabby. Should the ground from the output to tone be jumped over to the volume pot ground...
  4. Guitar: Gear Discussion
    Amp has arrived and sounds awesome. It even has my favorite power tubes in it... E34Ls! JJ's rather than Mullards, but I think these will last longer and hopefully not kill the screen grid resistors like Mullard's did. Anyways, I don't have a footswitch and I can't even use the solo boost...
  5. Guitar: Tech, Electronics and DIY
    I have a 3 way blade switch in my Jackson and want to know what connections are being made per position. I have put a continuity tester on it and the way it switches seems off to me. Where can I find a diagram of the internal working of 3 way blades? ETA Where is a good place online to buy...
  6. Guitar: Gear Discussion
    Not sure if this is the correct forum to post this in, Mods please move if this is the wrong forum. I use a MXR 108 10 band graphic in my loop and recently one of the sliders has started cutting out and would like to replace it. This is one of the older Blue boxed AC powered boxes. I was...
  7. Guitar: Tech, Electronics and DIY Here's the schematic for a 5150 II which is supposed to be the same as the 6505+. Can anybody tell me what the value for the Gain pot on the Crunch channel is?
  8. Guitar: Tech, Electronics and DIY
    Hi all, I'm going to build a pedal with the schematic below and I'm wondering if anyone knows what the red dots in the boxes mean and how to know to know which components connect? It's confusing me a bit.
  9. Guitar: Tech, Electronics and DIY
    Hi all, As you know, I'm a proud new member here. I am hoping someone would be so kind as to help me figure out some wiring strategy for the following setup: I have a SSH body. I will FR it with a GFS trem, which I hope is good cause it required some serious work. The pickups I plan on...
  10. Guitar: Tech, Electronics and DIY
    Hey guys, If someone could get me a copy of the schematic for the Mesa footswitch for the Roadster head, I would greatly appreciate it! Thanks!
1-10 of 10 Results