Metal Guitarist Forums banner

tale

  1. Guitar: Instrument Discussion
    We live only a few miles from the coast in Corpus Christi and for anyone not paying attention we're currently getting pre-hammered by Hurricane Harvey with the full hammer falling later today. The wind and rain doesn't bother me, but I was in Biloxi MS to help clean up after Katrina and the...
  2. Guitar: Instrument Discussion
    Rig-Talk ? View topic - Kiesel's customer service sucks! :rofl: well done, Jeff. How this company stays in business, I do not know.
  3. Guitar: Tech, Electronics and DIY
    There were number of firsts on these builds; some good, some not good, one that made me physically ill and nearly caused me to walk away from everything. It was this board that started it all. Now for the voices in my head as I proceed…. That amazing figure and just the right...
  4. Guitar: Tech, Electronics and DIY
    I just want to do a shout out thread about my experience with IbanezRules!!. I think people complain loudly when things go wrong, but when things go well don't often take the time to give it back...at least that's how my job goes, so I'm putting this out for Rich. I have an Ibanez RG2228...
  5. Computers, Electronics, Gaming & IT
    I've got a MM fiber run between two labs at work, and I need a switch/GBIC for either end. I'm torn between these two. 2960: Cisco Catalyst 2960 Series Switches Models Comparison - Cisco Systems 3560: Cisco Catalyst 3560-X Series Switches Models Comparison - Cisco Systems I don't need QOS or...
  6. Guitar: Instrument Discussion
    So my Mushok and Korina came in, and I picked them up yesterday. Also had a little bit of playing time, albeit through POD Farm, not my DC yet :( Both guitars are quite well made, I'm impressed with the build. No glaring problems. The Mushok has a little tiny paint flaw near the joint...
  7. Guitar: Instrument Discussion
    So I acquired a duncan over the weekend, a mono jack and a 500k pot to switch my guitar from an EMG to a passive. Being that it's a Rhoads, I had to fish the wire though the wing and into the control cavity, get the pickup in the ring and installed, etc. Once this was all done, I went to put...
Top