Metal Guitarist Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
86 Posts
Discussion Starter · #1 ·
I have the focusrite scarlett 2i2 (image behindhttps://images.musicstore.de/images/1600/focusrite-scarlett-2i2-_3_PCM0011153-000.jpg ) and the Fame audio PM 40 (image behind https://images.musicstore.de/images/1600/fame-audio-pm-400-powermixer-2x-75w-4-ohm-dsp-effekte_2_PAH0008094-000.jpg ) and these speakers Fame audio MC-10 (image behind https://images.musicstore.de/images/1600/fame-audio-mc-10-plus-200-watt-8-ohm_4_PAH0008254-000.jpg ) and i dont know how to connect the interface with speakers because the powermixer as you can see it has only one in/out!! :scream:
 

·
Premium Member
Joined
·
32,765 Posts
I don't think I see the problem...? You need a cable that's male 1/4" on one end and RCA on the other to run from the Scarlett to the poweramp, plugged into the CD/Tape In (which is poorly labeled, with the "in" on top and "CD/Tape" below, but the color-coding for a stereo RCA input is red and white for a stereo set), and then speaker cables running from each other speaker outputs on the poweramp to the input on your speakers.

Are there any front panel inputs or controls on the Powermixer? a 1/4" in is easier than RCA, but it'd still work if you use RCA, with the right cables.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top