Metal Guitarist Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
348 Posts
Discussion Starter · #1 ·

Livewire Passive direct box, Hosa ATT 448 inline attenuator set at -30 Db. I used a XLR female to 1/4" male to plug into an out on my audio interface. I reamped through my GSP 1101 to check the input level was good, and not too hot. Checked the signal through a JC 120 patch to make sure all was good as far as noise or what not. The clip is JSX Crunch channel and a Dimebag patch on the GSP that I tweaked. Solo I added a Rectifier patch from the GSP. Works great. I had the DI and attenuator lying around, just needed to get the XLR to 1/4" adapter. I used another Livewire DI to record the dry guitar signal to reamp.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top