Metal Guitarist Forums banner

New Pickups for my Carvin or Eric needs a soldering iron now!

4536 Views 21 Replies 15 Participants Last post by  ohio_eric
4
So here is my Carvin Bolt T in her current state.



Here's the new loaded up pickguard that's going in her. It's from Pete Biltoft at Vintage Vibe Guitars, who did my humbucker sized seven string P-90s. It's has SP-90 single coils in the neck and middle and a H540-42 humbucker that's 10% overwound in the bridge. The knobs are a master volume and a tone for the singles and one for the humbucker and a standard five way switch..



Here's a gratuitous butt shot.



Here's the knobs and screws that go with it.



I also got a spare set of magnets with the pickups. It has Alnico V installed and I asked for Alnico III as a back up set though you can request Alnico II or Ceramic VIII. The pickups are are designed for easy magnet swapping so I might pick up some Alnico VIII or Alnico IV magnets as well just for giggles.

For those who care I got my receipt for this order and Pete started work on May 22 and it arrived at my house on June 1. Not bad considering I had Carvin ship him a new pickguard, to ensure it would fit. Not including the cost of the new pickguard it ran me $295.
See less See more
  • Like
Reactions: 5
1 - 1 of 22 Posts
I think you should go to q parts and select some custom knobs to finish that bad boy off. :metal:
Thread full of mezand. :cool:
1 - 1 of 22 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top