Metal Guitarist Forums banner
1 - 20 of 21 Posts

·
Premium Member
Joined
·
23,428 Posts
Discussion Starter · #7 ·
Also, I had to log into eBay with an 8 year old account. I know this because it had an address in there that was, at the very least, 8 years old :lol:
 

·
Premium Member
Joined
·
32,450 Posts
How the hell did the faceplate gent bent? That's some heavy duty steel.
 

·
Premium Member
Joined
·
23,428 Posts
Discussion Starter · #11 ·
Probably from not having it in the rack. I've actually seen a few power amps with bent rack ears. Both rack ears on the Carvin T100 I have now are bent up :lol:
 

·
Premium Member
Joined
·
23,428 Posts
Discussion Starter · #19 ·
Just read this in the user manual:

5. Switching/Stereo switch: The RT2-50 has 2 modes of operation, 100 watts of Stereo operation, and 50 watts per channel in mono Switching mode. When assigning a specific channel to your guitar preamp, you must use Switching mode. Stereo mode can be used for running multiple cabinets at the same time. Tip: Switching mode can also be used with multiple cabinets, so you can switch back and forth between cabinets. Simply connect to Channel 1 input of your RT2-50 from your guitar preamp, and in switching mode, run a speaker cable from both Channel 1 and Channel 2 outputs to different cabinets. This allows you to run different sounds out of different cabinets and switch between them.
Fucking awesome!
 
1 - 20 of 21 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top