Metal Guitarist Forums banner
1 - 3 of 3 Posts

·
Read Only
Joined
·
10 Posts
Discussion Starter · #1 ·
I'm about to dig into recording direct with the AFX, but this applies to any setup, really.

As I understand it, I run a dry signal into my bus, then route it out through a bus with (amp_model_whatever) on it. So the signal coming into my software (say, Reaper) is essentially clean and gainless, and the gain is added after the fact, correct?

Then if I want to play something once, and hear it with a few different amp models, I just change the amp model and the signal path stays the same?
 

·
Read Only
Joined
·
10 Posts
Discussion Starter · #3 ·
I'm going AFX -> MOTU 8Pre -> Firewire -> Reaper right now. I assume I'd have to send the, uh, send, back into the AFX, and the return back into the bus?

[action=Chris]hasn't RTFM yet, keeping that in mind[/action]
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top